'System FRU not Programmed' Message - Solution

Question

Unit is a PE 2600 - The short of it was that I had to disconnect power from the power supplies to clear the error.   As always, make sure you have the latest BIOS and ESM firmware loaded too.   This is the second or so time this has occured on the box.  I think it may have occured on a different unit as well with the same solution working there too...   Hope this helps someone... Message Edited by DBakerMan on 05-23-2005 12:34 PM

NickZA · Answer

:smileyvery-happy:   Excellent! Thanks mate. A nice quick fix.

PowerEdge Hardware General

Was this post helpful?