Unsolved
This post is more than 5 years old
1 Message
0
305623
September 1st, 2013 16:00
T110 II DRAC Access
Hi,
I have a new T110 II Server that I have just installed for a client. I configured the DRAC whilst the server was booting with an ip address, subnet and gateway. It has a single NIC port - which I suspect may be significant in this post.
If I now try to access the DRAC, either on the server itself or remotely I get "page cannot be displayed". If I use the Server Administrator Utility I can confirm the DRAC setting are correct. It is also possible to ping the ip address of the DRAC. If I change the address in the Server Admin Util, the pingable address changes as expected. The port type is set to shared - as mentioned there is only one port on the server.
I am attempting to access the DRAC using https://theipaddress/
Should I put a port number on the end? I understood it uses 443 by default.
I have a feeling I am missing something blindingly obvious!
Any suggestions appreciated.
0 events found
Daniel My
10 Elder
•
6.2K Posts
0
September 1st, 2013 16:00
Hello carbonlite
The set up and configuration is very straightforward. It sounds like you have it configured properly. I suspect that you don't actually have an iDRAC. The T110 II has three options: BMC/iDRAC Express/iDRAC Enterprise. The only option of the three that does not support the web-based GUI you are trying to access is the BMC. You can boot into the BMC BIOS via CTL E and configure network settings with any of the three options, but only the iDRAC Express/Enterprise offer a web-based GUI. I would recommend double checking to make sure you have an iDRAC. You can review the iDRAC features on page 22 of the user's guide:
http://ftp.dell.com/Manuals/all-products/esuprt_electronics/esuprt_software/esuprt_remote_ent_sys_mgmt/integrated-dell-remote-access-cntrllr-6-for-monolithic-srvr-v1.7_User%27s%20Guide_en-us.pdf
Thanks
Daniel My
10 Elder
•
6.2K Posts
0
September 1st, 2013 16:00
Well, I was right and wrong. Your issue is that you don't have an iDRAC, that part I was correct about. The part I was incorrect about is that the iDRAC is an option on the T110 II. I show that the BMC is the only option on the T110 II. It is not possible to add an iDRAC or iDRAC enterprise to that server.
Thanks
mbrcomp2015
1 Message
0
March 31st, 2015 00:00
IPMIView by SuperMicro will allow you to access with a GUI.