Hi @DELL-Cares ,

Would you kindly look at this case? Picture provided by @Glen762 is definitely from a Dell cable with a proper part number. Thanks a lot in advance!

Hi @Glen762 ,

Would you provide a picture showing label of your exiting cable? Should be something like this:

The technical support department has already spoken with me about it and they tell me it is in fact a valid part number.

Hi again @Glen762 ,

So do they able to provide you a valid cable to be purchased?

If still not, you may try TN9TD, a 8pin-male-to-6+2pin-male PCIe power cable at 65cm. With proper cabling direction, it should be long enough for additional Quadro GPU.

I'll try calling again later today but so far on the parts side they have not been able to confirm that that part even exists. Thank you for that compatible part number, that one is even available used on fleaBay if need be. The truth is the one I'm looking for is actually longer than it needs to be but I wanted to keep them matching so I may end up just replacing both of them if the number you suggested is shorter to reduce excess Cable in the case. Less excess cable is more room for air flow

Have you tried Parts People? There a lot easier to deal with than Dell Parts, and they are a Dell Parts supplier