adding memory to 3000cn color laser printer

Question

Does anyone know how to add memory to the 3000cn color laser printer? I could not find any documentation in the manual on how to do this. Any help and/or links to the procedure would be appreciated.

Jakpro · Answer

Turn off your printer. Look at the left side of your printer and you will find a door. Open the door and you will find the memory upgrade slot. All you have to do is insert the memory and snap it into place. The printer will recognize it automatically when you power it back up.

Jakpro · Answer

If you download the user's guide in HTML, you will find the following instructions:

<ADMIN NOTE: Broken link has been removed from this post by Dell>

Your printer supports 64, 128, 256, and 512 MB additional memory cards.

NOTE: The 64 MB memory card comes with the optional duplex module. Before you use the optional duplex module, you need to install the 64 MB memory card on the printer. If you already have an existing memory card installed on the printer, you do not have to use the 64 MB memory card provided with your duplex module.

Make sure that the printer is turned off.
Remove the control board cover on the left side of the printer by pulling the notch.
Hold the memory card so the notch is aligned with the projection on the slot.
Push the memory card into the slot firmly.
Reattach the control board cover to the printer.

I keep a copy on my hard drive to refer to it.

Message Edited by Jakpro on 11-20-2005 02:41 PM

Message Edited by Jakpro on 11-20-2005 02:42 PM

sbrady · Answer

I had the same question and will attempt to install this afternoon. Did you have any problems installing?

Printers

Was this post helpful?