Help

Start a discussion

Vivekjaiswal001

updated

17 years ago

Solved!

Go to Solution
V

Vivekjaiswal001

49 Posts

0

901

October 15th, 2009 05:00

set HBA Flag

Hi,

I am a little confiused on the set hba command

So this is the usual command..

symmask -sid -wwn set hba_flags on os2007,spc2 -dir -p -enable

What if my windows OS is 2003... does this command still hold good???

or i gotta change above to set hba_flags on os2003


Thanks in advance,
Vivek
  • D

    dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    419

    0

    Posted October 15th, 2009 05:00

    OS2007 flag provides for "SCSI_Support1" functionality, not necessarily for specific OS only, HPUX 11.3 needs this flag as well. So use as "OS2007"
  • D

    dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    419

    1

    Posted October 15th, 2009 05:00

    Common_Serial_Number 
Disable_Q_Reset_on_UA 
Environ_Set 
Siemens 
Volume_Set_Addressing 
Avoid_Reset_Broadcast [ARB]
AS400 [AS4]
OpenVMS [OVMS]
SCSI_3 [SC3]
Sunapee [SCL]
Sequent [SEQ]
SPC2_Protocol_Version [SPC2]
SCSI_Support1 [OS2007]


    you need to make sure to use correct flags for your OS/clustering solution/application. If you go through E-lab navigator, it will provide the flags you need to set.
  • V

    Vivekjaiswal001

    49 Posts

    419

    0

    Posted October 15th, 2009 05:00

    Hi dynamox,

    Thanks for the quick reply.

    I am quite aware of these flags but my question is on the flags command for windows... it specifies to set on os2007 while mine is 2003.

    So do i need to make changes on that command as
    symmask -sid -wwn set hba_flags on os2003,spc2 -dir -p -enable

    OR keep it same

    symmask -sid -wwn set hba_flags on os2007,spc2 -dir -p -enable

    Thanks,
    Vivek
  • V

    Vivekjaiswal001

    49 Posts

    419

    0

    Posted October 15th, 2009 06:00

    Lovely,

    now m all set to go


    Thanks a ton!!!
    Vivek.

Dell Support Resources

Latest Solutions

View More