Unsolved
This post is more than 5 years old
3 Posts
0
1584
March 17th, 2020 05:00
idrac 9 / RedFish / racadm / LifeCycle Controller
Hi All
I am using Ansible to deploy some new Dell servers into our environment.
This is working well for configuring AD / email / NTP etc... but i would like to configure a partiular setting in the LifeCycle Controller "Link FEC" = CL74 -Fire Code, which is configured at boot time (F2) them under System Settings --> Device Settings --> (Nic 1....) --> Device Level Configuration
I can't seem to find this anywhere in the documentation, does anyone know where i find a command to set this ?
Many thanks
Alistair
No Events found!
Dell-DylanJ
6 Operator
•
2.9K Posts
0
March 17th, 2020 12:00
Hi,
I wasn't able to find a way to do this through commands, either, unfortunately. If you can share the specific firmware version you're running, it *MAY* help, but I can't promise that.
I'll freely admit that I'm pretty ignorant when it comes to Ansible. That having been said, have you happened to have seen this GitHub page? There might be some value there.
https://dell.to/2wePrTV
alistair4267
3 Posts
0
March 18th, 2020 02:00
Hi
iDRAC 9 version is 3.36.36.36(Build 21), I have had a look over the link you provided which help a bit, it's just i'm more intrested in getting the config out of the LifeCycle controller rather than have to set it manually. To be honest i only have another 14servers to do so it will just take me a bit longer to configure.
Cheers
Alistair
DELL-Shine K
6 Operator
•
3K Posts
0
March 18th, 2020 21:00
Can you provide details (Vendor and Model) of the controller for which you trying to configure the setting
alistair4267
3 Posts
0
March 19th, 2020 04:00
Hi Shine,
The Server is a
Is this what you are after ?
Many thanks
Alistair
DELL-Shine K
6 Operator
•
3K Posts
0
March 19th, 2020 06:00
I need details on network controller where where you are trying to configure below setting
"Link FEC" = CL74 -Fire Code,