Unsolved
This post is more than 5 years old
7 Posts
0
1179
September 8th, 2004 22:00
Please somebody can help me????
ok yesterday i did the upgrade of my windows upgrade( Windows XP Service Pack 2) and today i try to do my work using Vision Pro 6.0 ( engraving and routing software) but everytime that i hit any key on the keyboard like x is giving me a bunch of them (xxxxxxxxxxxxxxx) and i called my engraving support and they told that his is a commom problem but i caused for my upgrade and i have to deal with microsoft guys on this they told that you can give something like a pacth but i wan't to know if somebody can help in here cause their take ttheir time.
I already tried to reinstall the program and it doesn't work and this is the only program that is giving my this pain so far
Please somebody can help i really need to go back to work
Thank you
SuperGatito
7 Posts
0
September 9th, 2004 00:00
SuperGatito
7 Posts
0
September 9th, 2004 00:00
volcano11
2 Intern
•
28K Posts
0
September 9th, 2004 01:00
You are using highly specialized software that almost no one that visits these forums is likely to use. We have no idea what the software maker recomended in terms of a patch, because your message is not at all clear. The only thing I can suggest is to use System Restore to restore your system to the state it was in prior to installation of SP2 and wait on SP2 until the maker of the router and engraving software has a clear fix for the problem. Unless you can provide more information on the "patch" that the software maker recommended, I don't know what else to suggest.
Steve
SuperGatito
7 Posts
0
September 10th, 2004 00:00
Can you help me??
volcano11
2 Intern
•
28K Posts
0
September 10th, 2004 01:00
Unless you can be more specific about what patch the software people recommended, it is going to be very difficult to help you.
Steve