Unsolved
This post is more than 5 years old
2 Intern
•
369 Posts
0
4064
September 29th, 2005 18:00
slipstream
Do anyone know how to slipstream.
I would like to combine my xpsp1a disk with my sp2 disk so I end up with one disk called xpsp2. Dell wants $108 for it.
The reason I want one disk is so I can run a repair if necessary; I understand the disk and o.s must be the same to run a repair. I have read the site that explains this procedure but it is a bit over my head-could someone break it down for a non tech person?
Thank you
No Events found!
simpswr
2 Intern
•
3.2K Posts
0
September 29th, 2005 18:00
Shucks . . make it simple . . AutoStreamer does the work for you
Instructions here
wrs
Message Edited by simpswr on 09-29-2005 02:49 PM
npd424
2 Intern
•
369 Posts
0
September 30th, 2005 11:00
The article does not mention sp1a which is my original os disk-would this work also?
Thank you
simpswr
2 Intern
•
3.2K Posts
0
September 30th, 2005 12:00
s1x6x1s
3 Posts
0
September 6th, 2006 02:00
I don't know if you've successfully slipstream your SP1a with SP2 or not, but I'd like to share some knowledge.
I also used AutoStreamer to slipstream the service packs. But not all OEM CDs can be used directly as Windows source (as it happened with me). There was no error in the slipstreaming process, but I ended up with an ISO file that was still SP1a. The easiest way to see if the slipstream is successful, open the ISO file and see if there is a file called WIN51IP.SP2. If so, then you're good to go; just follow the next step in burning the ISO file to a CD (http://www.simplyguides.net/guides/using_autostreamer/using_autostreamer.html)
If the ISO file does not have WIN51IP.SP2 in it, then your XP SP1a CD from Dell cannot be used for slipstreaming. A way around that is to copy the entire content of the SP1a CD to a folder, then delete certain files from it (obviously these are files added/modified by Dell) and replace them with new files from another XP CD (instructions: http://vbdotnet.home.comcast.net/XP_SP2.htm). Then use that SP1a folder as your Windows source when using AutoStreamer. When you're done, open the ISO file and you'll see the WIN51IP.SP2 file in there.
Note: the irony to this step is that you have to get a hold of another (non-OEM) XP CD :p ...so borrow from someone
npd424
2 Intern
•
369 Posts
0
September 6th, 2006 10:00
s1x6x1s
3 Posts
0
September 13th, 2006 01:00
I'm unclear about your widescreen problem... did it happen after you install your slipstreamed XP or is it a display problem in general? Because I installed my slipstreamed XP and it was okay. If your monitor is a widescreen, XP should automatically re-adjust the minimum optimal screen resolution for your monitor.
In any case, try adjusting the resolution setting on the display properties. Hope this helps.
npd424
2 Intern
•
369 Posts
0
September 13th, 2006 12:00