This post is more than 5 years old
21 Posts
0
1106
How to split a 2 x-brick into seperate clusters?
Greetings, I am wondering if it's possible to divide a 2 xbrick system into 2 separate single xbrick XIO cluster.
Currently, the XMS detects 4 SC's.
What cables do I need to disconnect? Do I need to disable the infiniband switch? Do I need to put the 2 SC on xbrick 1 and the 2 SC on xbrick 2 to 2 separate vlans/subnets? Do I then need to deploy 2 separate XMS VM's?
Please let me know. This is in order to use our current XIO for 2 separate lab setups.
Thanks.
scotthoward
64 Posts
1
June 24th, 2015 16:00
It's not possible to split a dual brick into two single bricks - for a few reasons.
The first is the physical reason - you don't have enough components! Both a single and dual brick use 2 BBU's for redundancy. Thus if you were to split the array, you'd be short 2 BBU units as you'd need 4, but you only have 2.
The second is the logical reason - the two bricks currently share a serial number. If you were to split them they would both share the same serial number, which is not allowed and will confuse a lot of thing - including giving you duplicate WWPN's as of version 4.0!
echolaughmk
522 Posts
1
June 24th, 2015 16:00
This is not possible to my knowledge. The PSNT number set at the factory is across both bricks that make up the cluster and I don't believe it is possible to perform any factory reset or burn-in of a new PSNT serial when they are split up regardless of being able to discard the IB switches and connect the IB cables directly across SC's.