We have two P3424WEB monitors, where the camera has stopped working. The computers cannot detect the camera. I have tried to update the firmware from M2T101 to M2T103, but it keeps stopping after about 20% with the message: Update error. See help for step by step instructions, etc. Keeps getting this error with both monitors.
The USB upstream cable is connected. Anyone knows this issue and a possible solution?
Looks like there was a security update that is causing the issue. Uninstalled the security update (Setting > Windows Updates > Update history > Uninstall updates). After that I uninstalled the drivers for the monitor webcam, then restarted my PC.
When the PC finished booting, the monitor webcam was working again.
Re-ran the monitor firmware update (M2T103) and it completed successfully.
Ended up running around with a laptop, without the Jan-2025 security update, firmware updating all our monitors from M2T101 to M2T103. The firmware updates takes ~20mins per monitor, thankfully we only have a handful of these monitors.
I just part tried Chris M from Dell's solution 1) close webcam shutter 2) power off P3424WEB monitor - using round button on back 3) power back on .... and the camera became visible again in the Dell Peripheral Manager - so maybe just power cycling the P3424WEB using the button on back could be enough to bring the webcam back online 4) open shutter
Dell Support must verify the ownership and warranty status. Click the blue "Get Help Now" on the right to start a private live chat session. Share the private P3424WEB Service Tags with them.
* Rotate the P3424WEB webcam shutter clockwise to Closed * Turn the P3424WEB off via the rear power button * Disconnect the power cable from the P3424WEB * Press and hold the P3424WEB rear power button for 8 seconds * Reconnect the power cable to the P3424WEB * Turn the P3424WEB on * Rotate the P3424WEB webcam shutter counter clockwise to Open * Retest webcam in Microsoft Teams
I have the exact same issue. Webcam worked fine yesterday, today it no longer works. I attempt to update the firmware from M2T101 to M2T103 and it fails at about 20%. I have also tried firmware M2T102, which also fails. I connected the monitor to another PC and attempted the firmware update again, and it failed at the same spot.
@DELL-Chris M Yes, I followed the steps exactly. I have read the troubleshooting steps, and the firmware update instructions. While doing the firmware update, the only cables connected to the monitor was the USB-C going to the computer and power.
The camera shows as unhealthy in device manager (Device cannot start (code 10)). Camera shows this status in device manager on both a Windows 11 computer and another Windows 10 computer.
Then follow these instructions. Once GHN agents confirm warranty and your troubleshooting, they should setup a like for like monitor exchange.
Dell Support must verify the ownership and warranty status. Click the blue "Get Help Now" on the right to start a private live chat session. Share the private P3424WEB Service Tag with them.
DELL-Nat M
Community Manager
•
3726 Posts
•
21071 Points
0
0
Posted January 29th, 2025 16:22
Hi everyone,
Workaround for the Monitor Firmware Update Failure:
Affected Monitors:
Affected Windows Update:
Updated article: Dell Monitor P3424WEB, P2724DEB, or P2424HEB Experience Camera or Firmware Update Failure After January 2025 Windows Update
(edited)
#IWork4Dell