Hi All,

I need any input from any experience friend here due of some failover test that I failed during my testing. Below is summary of my failover testing.

• We have a PowerStore storage following the best practice for SAN connectiviy using iSCSI.
• Node A and and Node B are connected to 2 TOR switch via port 1 and port 2 (on I/O module) following Dell best practive.
• We have also bonded port 1 & 2 on powerstore and also on the Brocade switch using LACP. We did a connection test by removing the FC cable from each port one at a time to test whether VCenter was still up and it tested successfully.
• But when we did a test to remove both the FC cable from port 1 & 2 from Node A at at the same time, all the VM were hung and seems that it did not failover to Node B as expected.

 My question is if both FC cable is removed from port 1 & 2 on Node A at the same time, will SAN connectivity get distrupted or will it failover to Node B? Kindly advise if anyone has any idea on this. Very appreciate any input from anyone here. Thank you.