Solved!
Go to SolutionQuestion about Snapview scripting
Hello all,
I have a customer that has a Cx500 that they want to upgrade from R19 to R26. they have 3 AIX hosts attached to this array and they run a Perl script to create snapshots with Snapview.
I dont know AIX or Perl scripts but i remember that once i upgrade to R26, the old navicli commands will change to naviseccli.
My question is can i take thier script and just change every instance of "navicli" to "naviseccli"? i know i will have to create a security file on each hosts for the use that logs in to run the script. I have looked through the Snapview CLI PDF and it looks like all the basic commands have stayed the same.
The customer doesnt want to proceed unless we have a solution to the script.
Any advice would be great.
Thanks
But to do that i would have to upgrade them first correct?
Does the CX series have the option to enable/disable classic CLI like the CX3 and CX4 series does. If so i would think that i can make sure classic cli is enabled to make sure the script in teh current form works before trying to modify it to naviseccli commands.
Does this sound right?
Does that feature enable you to use both navicli & naviseccli commands at the same time or is it one or the other?
Ok, just ended a chat session with EMC and they told me that classic CLI is enabled by default all the way thru R29. So the array will accept the old navicli commands after being upgraded from R19 to R26. Sounds like i dont need to modify that script at all.
That option will disable the classic commands and require you to only use naviseccli commands.
Thanks Dynamox for looking at that script:)
dynamox
11 Legend
•
20419 Posts
•
87439 Points
587
0
Posted September 28th, 2010 08:00
they are not using return codes but are simply scrubbing standard out. Because they are looking for certain strings in the output i would make sure output from navicli and naviseccli looks identical. Setup a couple of test snap sessions and use their commands and then use naviseccli.