Hi,

After I ran through the initial setup via CLI, I typed this command in order to remove the 2x HDD spare from the raid10 that I created

member select membername raid-policy raid10-nospares

This worked well the first time and but now added 4x more HDD and 2x HDD has been added to the raid10 pool and 2x HDD was set as spares.

I run the same command again but nothing is happening.

Can anyone please advise how I can remove the spare and add them to the raid10 pool?

Is it because I now have a volume in the array and I am not allowed?

Any advice is very welcome.

Thank you