UNSOLVED
Optiplex 7060 Mid Tower amber light problem
My optiplex 7060 MT has had some issues over the past few days, it used to have a steady amber light but then it switched to 2 blinks then 1 and then now it doesnt even turn on or anything and i tried getting a new power supply but it hasnt changed anything, is my motherboard damaged? And how can I fix this?
0
0
Posted January 26th, 2024 20:14
See the diagnostic lights table below. Two amber lights was indication of bad motherboard. The following white LED state would help to determine system state. Since you had ruled out power supply, it could highly be a bad motherboard. A new board can be had for around $30 USD. Verify the part number for compatibility.
0
0
Posted January 26th, 2024 20:46
@Chino de Oro the thing is now not even an amber light pops up so I dont really know my problem, do you know anytjing about that? Maybe the motherboard got totally fried or smth
0
0
Posted January 26th, 2024 21:03
@Aaronzuhn , you had indicated that there were 2 amber lights before the system went completely dead. All I could do were gathering information you provided and giving the suggestions that may resolve the issue.
My previous comment was included a link to new motherboard for replacement. Verify the sticker on your current motherboard to see if it has a matching part number and decide for yourself if you want to replace the board.
0
0
Posted January 28th, 2024 23:57
@Aaronzuhn - Are you sure the replacement PSU is compatible with this PC model, is correctly connected and actually works?
I'd run the BIST on the PSU. From the pics in the setup guide your PC has a PSU status LED on the back below the power cord socket, but not a PSU test button. Either way the link (above) provides instructions to run the BIST on a PC with or without the test button.
0
0
Posted January 29th, 2024 02:20
Before giving up on the MB, try changing or test the 3v size 2032 battery and do a BIOS reset.
Granted the PSU is the correct one, bad MB is likely. Can also check for the possibility of bulging capacitors (unlikely with newer design) or if anything shows signs of getting too hot.
OptiPlex 7060 Tower Service Manual
Be sure to do the BIST (Built In Self Test) as mentioned by RoHe.
(edited)
JOcean
11 Legend
•
12621 Posts
•
69453 Points
0
0
Posted January 26th, 2024 20:08
The 2 , 1 blink indicates a failed CPU. In the slightly older Optiplex series it can also mean a motherboard failure.
I am not a Dell employee...I am forum volunteer
Serious work on an E5430 and constantly building and working on an i5-6500 Desktop