December 5th, 2005 08:00

Hello,
 
What do you call diagnostic page ? if it is the internal test page so you may have a problem with your additional memory ...
You can't use PS with the 3000cn, the only solution is to have more memory ...
I've heard gloss paper is not recommanded for this printer.

11 Posts

December 5th, 2005 22:00

You have to make sure the ram pushes all the way in and level.  I installed the 512 chip and it didn't take the first time.  I took it out and put it back in and made sure it was level and then worked fine and is visible on the diagnostic sheet.
No Events found!

Top