Hello

we just want to know what could possibly cause these kind of errors to the servers and what is the possible solutions , knowing the we tested the supposed to be defected CPUs in other servers and it works fine.

None of the errors point to a cause. Most of the errors you are receiving are typically symptoms of other problems.

Check the CMC log to see if there are any reported power issues from the CMC. If there are no power errors in the CMC then you should perform more information gathering and troubleshooting on the problem blades. Find out if they have anything in common that separates them from the other blades. Are they scattered around the chassis or are they all next to each other in the chassis? Try moving them to different slots to see if the problem follows the blade or stays with the slot.

You should also review the system event logs of the blades further to look for additional errors. Your issues can be anything from a driver to an electrical problem. You need to gather more information. You could also run diagnostics.

Thanks

Hi Daniel,

thank you for reply,

i tried to move servers around different slots, the errors are following the servers not slots, the defected servers are scatters  around the chassis, the CMC log dos't show any power issues.

the defected servers doesn't even boot so i cant gather any sys log  information.

i minimized the servers configuration to the minimum, 1 CPU  and 1 memory module and the problem remains.

i checked the CPUs in other servers and they worked fine.

Thank you