Skip to main content
Start a Conversation

Unsolved

This post is more than 5 years old

S

SluggoMagoo

3 Posts

20386

February 21st, 2018 10:00

blink/unblink physical disk

Hello all,

I'm new to racadm raid commands but I was able to find some useful commands. I got a question regarding blink/unblink. How do I get the status of the blink flag after using "racadm raid blink:Disk.Bay.4:Enclosure.Internal.0-0:RAID.ChassisIntegrated.1-1" or "racadm raid unblink:Disk.Bay.4:Enclosure.Internal.0-0:RAID.ChassisIntegrated.1-1"

DELL-Daniel My

Moderator

 • 

6.2K Posts

February 21st, 2018 13:00

Hello

Please send a private message with your service tag to ensure we have all appropriate information on your system.

Thanks

SluggoMagoo

3 Posts

February 22nd, 2018 02:00

@DELL-Daniel My wrote:

Hello

Please send a private message with your service tag to ensure we have all appropriate information on your system.

Thanks

I don't seems to have access to private messages. I'm working on a PowerEdge VRTX.

DELL-Daniel My

Moderator

 • 

6.2K Posts

February 22nd, 2018 11:00

@SluggoMagoo wrote:

I don't seems to have access to private messages. I'm working on a PowerEdge VRTX.

I don't show that you are a member of the registered users group. There may be something in your account setup that is not completed.

I have been unable to find anywhere that the blink status is monitored. I doubt this is something that is reported. I have been unable to find any management or monitoring program that reports the current blink status. The only capability I have found is to send either a blink or unblink command. Based on my research, it does not appear possible to get the blink status..

Thanks

SluggoMagoo

3 Posts

February 22nd, 2018 11:00

@DELL-Daniel My wrote:
@SluggoMagoo wrote:

I don't seems to have access to private messages. I'm working on a PowerEdge VRTX.

I don't show that you are a member of the registered users group. There may be something in your account setup that is not completed.

I have been unable to find anywhere that the blink status is monitored. I doubt this is something that is reported. I have been unable to find any management or monitoring program that reports the current blink status. The only capability I have found is to send either a blink or unblink command. Based on my research, it does not appear possible to get the blink status..

Thanks

So if you're not in front of the array, you can't tell if the lights blinking? :smileysad:

View More

View All

No Events found!

Top