This post is more than 5 years old
21 Posts
0
2522
Avamar and Backup & Recovery Manager
Hi,
Question has anyone seen Backup & Recovery Manager show their Avamar Systems as Offline when all before they were communicating correctly with Backup & Recovery Manager. I do not if I need to remove the systems in question and then reinstall if possible the Avamar Adaptors on each system?
Everyone help is always much appreciated.
Thanks,
dklebba
13 Posts
0
May 21st, 2013 07:00
Log into the Avamar Utility Node as admin
adaptorctl.pl --stop
adaptorctl.pl -–setup -–jmsaddr=
adaptorctl.pl --start
dklebba
13 Posts
1
May 16th, 2013 12:00
I had this happen. I stopped the avamar adapter and restarted it and it seemed to help.
fdxpilot
143 Posts
1
May 16th, 2013 12:00
I'd recommend opening a case for this so support can take a look at it. We've had to restart MCS in the past to get BRM back in sync with Avamar but we've always worked with support to diagnose the issue first.
hardybri1965
21 Posts
0
May 21st, 2013 07:00
Since I'm new to Backup and Recovery Manager how do I go about restarting the adapter without rebooting the server.
hardybri1965
21 Posts
0
May 21st, 2013 08:00
For BRM hostname should I use the FQDN for the BRM server, shortname or IP Address and thanks.