Start a Conversation

WillSanders

1 Rookie

•

63 Posts

0

1029

October 5th, 2015 14:00

VNX Monitoring & Reporting Alert Sample Time

Hello,

Is there a way to set a minimum sample time before M&R sends and alert?

For example, a LUN almost always runs below 5ms response time, but every so

often, for one sampling, the LUN spikes above 20ms. This one 20ms+ sampling

will cause M&R to send an alert. Is there a way to tell M&R to only alert if there

are "n" or more samples above the threshold?

Thanks,

Will S.

Responses(3)

Jyothi_P_Bharat

317 Posts

0

October 6th, 2015 02:00

Hi WillSanders,

Please check the below mentioned document,it might help you(page number 30):

http://www.emc.com/collateral/TechnicalDocument/docu43305.pdf

Thanks

Jyothi

WillSanders

1 Rookie

•

63 Posts

0

October 6th, 2015 06:00

Thanks for sending this along. I had looked at this before, and hadn't found a way to change alerting to look at sample time. Guess there isn't a way to do it.

Thanks

WillSanders

1 Rookie

•

63 Posts

0

October 6th, 2015 20:00

Thanks for the link, but unfortunately it doesn’t appear that M&R is capable of

looking at sampling times for alerting. If there is a quick, single spike, it appears

as if an alert is sent. It would be nice if it was configurable to say that multiple

samples in a row need to be beyond the threshold before an alert is sent.

Thanks again.

View All

No Events found!