Unsolved
This post is more than 5 years old
11 Posts
0
1837
Li-ion SPS modules
Hi,
The SPS provides backup power to flash I/O modules in case of power failure during the vaulting process. My question is that how SPS is connected to Brick Engine in VMAX All Flash.
Rasmmacias
108 Posts
0
April 26th, 2018 08:00
The Li Ion SPS is a FRUable 10-lb battery, removed from the front of the system. The SPS transports separately and will be part of the install procedure. SPS units have 2.2KW capacity, and provide two five-minute intervals of battery life to allow vaulting in the event of a power failure. In System Bay 1 of a single engine bay, there are up to two SPS trays (four SPSs total) to support the engine and Fabric, if installed. In System Bays 2 through 8, there is only one SPS tray (two SPSs) to support the engine.
When installed in System Bay 1, SPS 1A and 1B are cabled to both the engine and the fabric, and SPS 3A and 3B are also cabled to both the engine and the fabric. This is true in multi-engine systems only. In single engine systems, SPS 3A and 3B support the engine only.
Rasmmacias
108 Posts
0
April 26th, 2018 08:00
In System Bay 1 of a dual engine bay, there are up to three SPS trays (six SPSs total) to support the engines and Fabric, if installed. In System Bays 2 through 4, there are up to two SPS trays (four SPSs total) to support the engines.
When installed in System Bay 1, SPS 1A and 1B are cabled to both the engine and the fabric, and SPS 3A and 3B are also cabled to both the engine and the fabric. This is true in multi-engine systems only. In single engine systems, SPS 3A and 3B support the engine only.