Unsolved
This post is more than 5 years old
1 Message
1
1116
June 9th, 2017 10:00
R720 iDRAC8
I am currently trying to configure iDrac on a company server and the LCD panel on the front seems to be permanently off. I was reading on this and it says the LCD cables may have gotten loose or I need to replace the control panel. Is there a way to configure the Idrac ip subnet and default gateway without the LCD? Could I restart the server and boot to it like in Idrac7?
0 events found
No Events found!
DELL-Chris H
7 Practitioner
•
9.7K Posts
1
June 9th, 2017 12:00
ColbyG,
What you will need to do is hit F10 at the Dell splash screen. Once in the Lifecycle Controller scroll to the bottom of the list and select System Setup - Advanced Hardware Configuration - iDrac Settings - Network, then under IPv4 you can set the IP address. Then be certain to hit Apply before leaving.
Let me know if this helps you.