CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Removing the internal dual SD module:
Locate the internal dual SD module (IDSDM) on the system board.
If installed, remove the SD card(s).
Temporarily label each SD card with its corresponding slot before removal. Install the SD card(s) into the same slots.
Hold the pull tab and pull the dual SD module out of the system board.
Installing the internal dual SD module:
Locate the internal dual SD module (IDSDM) connector on the system board.
Align the connectors on the system board and the IDSDM.
Push the IDSDM until it is firmly seated on the system board.
Install the SD card(s), if applicable.
Install the air shroud.
Follow the procedure listed in After working inside your system.
Install the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
