PowerPath Management Appliance: Running rpowermt commands return "ERROR: Host XXX not found in the PPMA database"
Summary: Running rpowermt commands return "ERROR: Host XXX not found in the PPMA database"
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
"ERROR: Host XXX not found in the PPMA database" signifies that PPMA doesn't find the ESXi details in its database.
Cause
From the PPMA 3.4 version and above, to run rpowermt command from PPMA CLI, the ESXi host should be attached to vCenter and the same vCenter should be added to PPMA.
Resolution
Add the corresponding vCenter under which the ESXi is added and rpowermt commands should run fine.
Additional Information
Refer to the PPMA Installation and Configuration Guide and the Release Notes for details.
Article Properties
Article Number: 000215253
Article Type: Solution
Last Modified: 09 Aug 2023
Version: 4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.