PowerEdge: 기본 설정 적용 시 Dell E810-2C 네트워크 어댑터 오류 발생
Summary: Dell 인텔 E810-2C 이더넷 어댑터에 기본 설정을 적용하려고 하면 오류가 발생합니다. 이러한 어댑터는 Permit Total Port Shutdown이 활성화된 상태로 구성됩니다. 두 포트 모두 포트 옵션이 4x25로 설정되어 있습니다.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
기본값으로 설정하면 다음 오류가 발생할 수 있습니다.
Cause
이는 포트 열거와 관련된 설계 제한 사항입니다. 포트 옵션을 변경할 때 다른 변경은 하지 않아야 합니다. 기본값으로 설정하면 모든 구성 옵션이 한 번에 변경됩니다.
Resolution
이 문제를 해결하려면 이러한 설정을 수동으로 기본값으로 변경합니다.
- 총 포트 종료 허용: Disabled
- 포트 옵션: 옵션 0: 1x100G 2개
Affected Products
Intel PRO Family of Adapters, PowerEdge R350, PowerEdge R440, PowerEdge R450, PowerEdge R540, PowerEdge R550, PowerEdge R640, PowerEdge R6415, PowerEdge R650, PowerEdge R650xs, PowerEdge R6515, PowerEdge R6525, PowerEdge R740, PowerEdge R740XD
, PowerEdge R740XD2, PowerEdge R7415, PowerEdge R7425, PowerEdge R750, PowerEdge R750XA, PowerEdge R750xs, PowerEdge R7515, PowerEdge R7525, PowerEdge R840, PowerEdge R940, PowerEdge R940xa, PowerEdge T350, PowerEdge T360, PowerEdge T550, PowerEdge T560, PowerFlex appliance R650, Powerflex appliance R750, PowerFlex appliance R640, PowerFlex appliance R740XD, PowerFlex appliance R7525, PowerFlex appliance R840
...
Article Properties
Article Number: 000221407
Article Type: Solution
Last Modified: 07 May 2025
Version: 3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.