How to Save and Restore Library configuration and Restore Factory Defaults on a TL2000 or TL4000

Summary: Here you can find the description how to Save and/or Restore the Library configuration and the Restore Factory Defaults on a TL2000 or TL4000.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

To
Save the Library Configuration.
Go to Save/Restore under the Configure Library section. 
Click Save at the Save Configuration to File.
SaveLibconfig1.png

The Download is provided using the Browser.
SaveLibconfig2.png

The *.dbb File is located in your Downloads folder from your management system. 
SaveLibconfig3.png


To
Restore the Library Configuration.
Go to Save/Restore under the Configure Library section. 
Click Browse… at the Restore Configuration from File.
RestLibconfig1.png

Select the configuration file (*.dbb) from your management system.
RestLibconfig2.png

Click Restore at the Restore Configuration from File.
RestLibconfig3.png

Be aware: If you load a configuration from another Library, the ServiceTag is overwritten too, and it should be corrected afterwards. A description how to do that you can find here: How to change the ServiceTag of a PowerVault TL2000 or TL4000.


To
Restore Factory Defaults
Go to Save/Restore under the Configure Library section. 
Click Restore at the Restore Factory Defaults.
LibconfigDefault1.png

Confirm the prompt on the screen with OK.
LibconfigDefault2.png

Affected Products

PowerVault TL2000, PowerVault TL4000
Article Properties
Article Number: 000205962
Article Type: How To
Last Modified: 27 Mar 2023
Version:  3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.