ECS: CAS behavior for cross bucket access under same namespace is not supported in ECS-CAS
요약: CAS behavior for cross bucket access under same namespace is not supported in ECS-CAS.
이 문서는 다음에 적용됩니다.
이 문서는 다음에 적용되지 않습니다.
이 문서는 특정 제품과 관련이 없습니다.
모든 제품 버전이 이 문서에 나와 있는 것은 아닙니다.
지침
CAS behavior for cross bucket access under same namespace is not supported in ECS-CAS. Centera supports this type of behavior. This is known limitation in ECS-CAS implementation, and it comes from the architectural differences between Centera and ECS.
Description:
There are two CAS buckets under one namespace TEST.
dc_bucket
dr_bucket
There are two object users to have these buckets as default CAS bucket.
dc_profile has dc_bucket as default CAS bucket
dr_profile has dr_bucket as default CAS bucket
The below ACLs were configured.
dc_bucket: dc_profile -> Full, dr_profile -> Read and Read ACL
dr_bucket: dc_profile -> Read and Read ACL, dr_profile -> Full
After writing one object to ECS using dc_profile PEA, this clip can be accessed using dc_profile. However, clip cannot be accessed using dr_profile and see that this Error message was -10021 (CLIP_NOT_FOUND).
Description:
There are two CAS buckets under one namespace TEST.
dc_bucket
dr_bucket
There are two object users to have these buckets as default CAS bucket.
dc_profile has dc_bucket as default CAS bucket
dr_profile has dr_bucket as default CAS bucket
The below ACLs were configured.
dc_bucket: dc_profile -> Full, dr_profile -> Read and Read ACL
dr_bucket: dc_profile -> Read and Read ACL, dr_profile -> Full
After writing one object to ECS using dc_profile PEA, this clip can be accessed using dc_profile. However, clip cannot be accessed using dr_profile and see that this Error message was -10021 (CLIP_NOT_FOUND).
해당 제품
ECS Appliance Hardware Gen1 U-Series제품
ECS Appliance, ECS Appliance Hardware Gen1 U-Series문서 속성
문서 번호: 000022400
문서 유형: How To
마지막 수정 시간: 01 3월 2023
버전: 5
다른 Dell 사용자에게 질문에 대한 답변 찾기
지원 서비스
디바이스에 지원 서비스가 적용되는지 확인하십시오.