PowerPath/VE 6.6 throws mpapi error
Summary: PPVE 6.6 supports VM count/info only for ESXi 6.7 & above and it throws warning message for ESXi 6.0.x and ESXi 6.5.x.
Acest articol se aplică pentru
Acest articol nu se aplică pentru
Acest articol nu este legat de un produs specific.
Acest articol nu acoperă toate versiunile de produs existente.
Symptoms
New install or Upgrade to Powepath/VE 6.6
Issue with Powerpath/VE 6.6 and PowerMAX there is an error thrown as follows: PowerPath: emcp_mpapi: Error: Esxi 6.500000 is not supported
Issue with Powerpath/VE 6.6 and PowerMAX there is an error thrown as follows: PowerPath: emcp_mpapi: Error: Esxi 6.500000 is not supported
Cause
PPVE 6.6 has this limitation on one of the PowerMAX integration feature (Host registration) where PowerPath reports active VM's information to PowerMAX array. This feature is applicable only for ESXi 6.7 & higher versions because of CIM provider class limitation from VMWare side. So any lower versions of ESXi will throw below warning messages in the logs.
Resolution
This error can be ignored since it logs this message for any lower ESXi versions than 6.7.
Produse afectate
PowerPath/VE for VMwareProduse
PowerPath/VE for VMwareProprietăți articol
Article Number: 000052429
Article Type: Solution
Ultima modificare: 17 oct. 2025
Version: 3
Găsiți răspunsuri la întrebările dvs. de la alți utilizatori Dell
Servicii de asistență
Verificați dacă dispozitivul dvs. este acoperit de serviciile de asistență.