Killer Wireless Firmware Update Guide for Ubuntu Systems

No symptom information is available.

No cause information is available.

Updating the Killer Wireless in Ubuntu

There are two ways to update the drivers for the Killer Wireless card. The simplest method is to update the Linux Firmware package as a whole, which is outlined in the first section below.

If you only want the specific Killer Wireless driver, you can pull that from the Linux Firmware and install it as well, which has been outlined in the second section below.

Table of Contents:

1. Linux Firmware Package
2. Killer N1535 Wireless Manual Firmware Update

Linux Firmware Package

Update your system with the following commands:

1. cd ~ && mkdir linux-firmware && cd linux-firmware
2. wget https://mirrors.edge.kernel.org/ubuntu/pool/main/l/linux-firmware/linux-firmware_1.187_all.deb
3. sudo dpkg -i *.deb
4. sudo modprobe -r ath10k_pci && sudo modprobe ath10k_pci

Note: To determine the current linux-firmware package available go to: https://mirrors.edge.kernel.org/ubuntu/pool/main/l/linux-firmware/

Back to Top

Killer N1535 Wireless Manual Firmware Update

The Killer N1535 manual firmware update process.

1. In a Terminal, confirm the QCA6174 with this command (Figure 1): sudo lspci | grep –i qca6174
   
   Figure 1
    
2. Download the latest firmware and extract the contents: https://codeload.github.com/kvalo/ath10k-firmware/zip/master
3. Or you can Download the ZIP and save it with the browser at this url as shown: https://github.com/kvalo/ath10k-firmware (Figure 2)
   
   Figure 2
    
4. Open the Downloads folder, then Right Click the ath10k-firmware-master.zip and extract here.
5. Confirm the contents of the extracted folder as shown. You should see the "QCA6174" folder (Figure 3).
   
   Figure 3
    
6. Back in Terminal, type sudo nautilus to open a root privilege file manager (Figure 4).
   1. Sudo nautilus
   2. Click Computer.
   3. Click folder lib.
   
   Figure 4
    
7. Go to the QCA6174 firmware directory (Figure 5).
   1. Click Firmware
   2. Click to open ath10k
   3. Right-click and Delete the QCA6174 directory (we are removing everything).
   
   Figure 5
    
8. Go to your other file manager window where your extracted download folder is (Figure 6):
   1. Confirm your new source file location in Downloads/auth10k-firmware
   2. Confirm your new destination file location in ../firmware/ath10k
   3. Copy and paste the QCA6174 directory with all its contents into the destination directory as shown. The path should be: /lib/firmware/ath10k/
   
   Figure 6
    
9. Open /lib/firmware/ath10k/QCA6174/HW3.0 and rename the file: firmware-4.bin_WLAN.RM.2.0-00180-QCARMSWPZ-1 To: firmware-4.bin (Figure 7)
   
   Figure 7
    
10. Now reboot and test the new Killer Wi-Fi firmware.

Back to Top