Enable HTTPS/SSH and disable HTTP/Telnet for switch management on PowerConnect 8000 and 8100 series switches.
摘要: This article provides the steps necessary to restrict management access using HTTPS and SSH.
本文章適用於
本文章不適用於
本文無關於任何特定產品。
本文未識別所有產品版本。
說明
This procedure assumes:
The switch is already configured with an IP address and is reachable within the network.
There is an account created with Privilege Level 15. To verify this, use the command: console#show users accounts
Caution:
The 8000 and 8100 series requires a Privileged Exec (Enable) mode password for telnet/SSH management. Failure to set this password will result in severely limited CLI management ability with SSH. ***Add link to setting enable password via web and CLI
This process requires use of the Command Line Interface (CLI). This process can be utilized through a serial or telnet session. However if telnet is used, these steps must be followed in order to prevent unintentionally blocking access to remote management.
Before disabling either telnet or HTTP access, verify SSH or HTTPS access.
The 8000 and 8100 series requires a Privileged Exec (Enable) mode password for telnet/SSH management. Failure to set this password will result in severely limited CLI management ability with SSH. ***Add link to setting enable password via web and CLI
This process requires use of the Command Line Interface (CLI). This process can be utilized through a serial or telnet session. However if telnet is used, these steps must be followed in order to prevent unintentionally blocking access to remote management.
Before disabling either telnet or HTTP access, verify SSH or HTTPS access.
Note: After completing these steps, you can expect to receive errors about certificate authenticity. This is due to the certificates and keys being self-generated. This is not an error.
Note: If SSH or HTTPS is enabled and the disabling of telnet and HTTP is desired, skip to step 3 to disable telnet and step 5 to disable HTTP.
This system is capable of the generation and storage of 2 certificates. To generate the second key, replace the number 1 with 2. To activate the second key, use (config)# ip http secure-certificate 2.
This system is capable of the generation and storage of 2 certificates. To generate the second key, replace the number 1 with 2. To activate the second key, use (config)# ip http secure-certificate 2.
- Connect to the switch via CLI
- To enable SSH, enter the following commands:
- console>enable
- console#config
- console(config)#crypto key generate rsa
- console(config)#ip ssh server
- To disable telnet, enter: console(config)# ip telnet server disable
- To enable HTTPS, enter the following commands"
- console(config)# crypto certificate 1 generate
- console(config-crypto-cert)#key-generate <512-2048>
- console(config-crypto-cert)#exit
- console(config)# ip http secure-server
- To disable HTTP, enter: console(config)# no ip http server
- After verifying connectivity via SSH or HTTPS, save the configuration by entering: console#copy running-config startup-config
受影響的產品
PowerConnect 8024, PowerConnect 8024F, PowerConnect 8100 Series文章屬性
文章編號: 000120235
文章類型: How To
上次修改時間: 05 6月 2025
版本: 7
向其他 Dell 使用者尋求您問題的答案
支援服務
檢查您的裝置是否在支援服務的涵蓋範圍內。