Cannot PXE Boot to a Dell USB Type-C to Ethernet Dongle

摘要: This article addresses an issue affecting PXE booting to a Dell USB Type-C to Ethernet dongle.

本文章適用於 本文章不適用於 本文無關於任何特定產品。 本文未識別所有產品版本。
查看其他資源

症狀

Users may be unable to PXE boot with the Dell Type-C to Ethernet dongle. The symptom encountered is that there is no PXE option listed in the F12 boot menu.

    原因

    BIOS configuration.

    解析度

    The solution is to set the system Fastboot to "Thorough" in the BIOS.  You can find the Options at Post Behavior > Fastboot. For detailed instructions on entering and configuring the BIOS, reference your system manual available for download from the Dell Support website: https://www.dell.com/support/home .

    The following additional configuration changes may be necessary to successfully PXE boot depending on the environment:

    • PXE needs to be enabled under the NIC
    • Current systems will require the UEFI network stack to be enabled
    • IPV4 should be enabled and IPV6 should be disabled (unless the network is configured for IPV6)

    受影響的產品

    Alienware, Inspiron, OptiPlex, Vostro, XPS, G Series, G Series, Alienware, Inspiron, Latitude, Vostro, XPS, Latitude Tablets, Surface, XPS Tablets, Fixed Workstations, Mobile Workstations
    文章屬性
    文章編號: 000148936
    文章類型: Solution
    上次修改時間: 21 5月 2025
    版本:  10
    向其他 Dell 使用者尋求您問題的答案
    支援服務
    檢查您的裝置是否在支援服務的涵蓋範圍內。