Precision 3930 Rack RTX card Installation Guide

Installing the Dell turing card

1. Follow the procedure in Before working inside your computer.

   NOTE: : The system will not power on if the top cover is removed. If the top cover is removed while the system is powered on, the system sounds an alarm for 4 seconds and shuts down.

2. To remove the cover:
   1. Using a Phillips screw driver, rotate the lock to unlock position to release the latch [1].
   2. Pull the latch back to release the top cover [2].
   3. Lift the top cover away [3] from the system.
   
3. Un-route the graphics card power cable from retention clips on the graphics card fan cage.
   
4. Holding the blue contact points remove the riser1 module from the slot.
   
5. Pull the release tab [1] to open the riser1 slot and lift the riser blanks [2] from the slot.
   
6. Install the turing card:
   1. Slide the turing card into the riser 1 slot [1].
   2. Close the riser module release latch [2].
      
   3. Connect the power cable to the turing card module [1]. Align the riser1 module with the alignment pins on the chassis and insert the riser1 module into the slot [2].
      
7. Route the GPU power cable through the retention clips on the graphics card fan cage.
   
8. Install the cover:
   1. Align the top cover tabs with the slots on the system chassis [1] and slide it into the slot.

      NOTE: : Ensure that all internal cables are routed correctly and connected before securing the top cover.

   2. The release latch automatically locks the top cover to the system.
   3. Using a Phillips screw driver, rotate the lock to secure the release latch
      
9. Follow the procedure in After working inside your computer.