- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Memory modules
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Solid state drive—M.2 slot three
- Solid state drive—M.2 slot four
- Solid-state drive interposer board
- Wireless card
- Hard drive
- Rear-I/O cover
- Audio daughter-board
- Speakers
- Card-reader board
- Coin-cell battery
- Computer base
- Touchpad
- Display assembly
- Heat-sink assembly
- Processor
- Graphics card
- Left power-adapter port
- System board
- Right power-adapter port
- Keyboard
- Palm-rest assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware Area-51m R2 Service Manual
Installing the M.2 2280 solid-state drive in M.2 slot two
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed in M.2 slot two.
NOTE: Depending on the configuration ordered, the computer may have up to four M.2 solid-state drive installed. The solid-state drive configurations that are supported on M.2 slot two are as follows:
- M.2 2230 solid-state drive
- M.2 2280 solid-state drive
NOTE: Install the solid-state drive to M.2 slot one before installing the solid-state drive to M.2 slot two on the system board.
The following image indicates the location of the M.2 2280 solid-state drive in M.2 slot two and provides a visual representation of the installation procedure.
Steps
- Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 solid-state drive slot on the system board.
- Slide the M.2 2280 solid-state drive into the M.2 solid-state drive slot on the system board.
- Slide the tab on the thermal shield into the slot on the computer base to secure the thermal shield in place.
- Align the screw holes on the thermal shield with the screw holes on the computer base.
- Replace the screw (M2x3) that secures the solid-state drive and the thermal shield to the computer base.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\