- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Base cover
- Battery
- Memory modules
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Solid state drive—M.2 slot three
- Solid state drive—M.2 slot four
- Solid-state drive interposer board
- Wireless card
- Hard drive
- Rear-I/O cover
- Audio daughter-board
- Speakers
- Card-reader board
- Coin-cell battery
- Computer base
- Touchpad
- Display assembly
- Heat-sink assembly
- Processor
- Graphics card
- Left power-adapter port
- System board
- Right power-adapter port
- Keyboard
- Palm-rest assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware Area-51m R2 Service Manual
Installing the rear-I/O cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear-I/O cover and provides a visual representation of the installation procedure.
Steps
- Align the tabs on the rear-I/O cover with the slots on the computer base, and snap the rear-I/O cover into place.
- Replace the four screws (M2.5x2.5) that secure the rear-I/O cover to the computer base.
- Replace the two screws (M2.5x7) that secure the rear-I/O cover to the palm-rest assembly.
- Adhere the tron-light cable to the computer base and connect the tron-light cable to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\