Alienware m17 R4 Service Manual

Removing the base cover

CAUTION Ensure that all captive screws are loosened before prying up the base cover.

The following image indicates the location of the base cover and provides a visual representation of the removal procedure.

Image: Removing the base cover

Image: Disconnecting the battery from the system board

Remove the two screws (M2.5x9) that secure the base cover to the palm-rest assembly.
Loosen the six captive screws.
Using a plastic scribe, pry the base cover from the gap around the screw holes to release clips on the base cover from the palm-rest assembly.
Work on the sides to pry open the base cover.
Lift the base cover off the palm-rest assembly.
Disconnect the battery from the system board.
NOTE Disconnect the battery cable only when you are continuing to remove other components from your computer.
Press and hold the power button for 5 seconds to ground the computer and drain the flea power.