- Notes, cautions, and warnings
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
Power specifications
- Power supply unit
- Specifications
- Wattage
- 1100 W (1050 W for low line)
1600 W (800 W for low line)
2000 W (1000 W for low line)
2400 W (1400 W for low line)
- Connector
- Card Edge
- Heat dissipation
- 394 BTU/hr (full load for the power supply unit only) (1100 W power supply unit)
- 475 BTU/hr (full load for the power supply unit only) (1600 W power supply unit)
- 635 BTU/hr (full load for the power supply unit only) (2000 W power supply unit)
- 760 BTU/hr (full load for the power supply unit only) (2400 W power supply unit)
- Maximum inrush current
- 25 A
- System voltage requirements
- 100 – 240 V ACNOTE: This system is also designed to be connected to IT power systems with a phase to phase voltage not exceeding 230 V.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\