Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

duplex

Configures Duplex mode on the Management port.

Syntax
duplex {full | half | auto}
Parameters
  • full — Set the physical interface to transmit in both directions.
  • half — Set the physical interface to transmit in only one direction.
  • auto — Set the port to auto-negotiate speed with a connected device.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
You can only use this command on the Management port. The no version of this command removes the duplex mode configuration from the management port.
Example
OS10(conf-if-ma-1/1/1)# duplex auto
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\