Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

match dscp

Configures a DSCP value as a match criteria for a class-map.

Syntax
match [not] {ip | ipv6 | ip-any } dscp [dscp-value] [ecn ecn-value]
Parameters
  • not — (Optional) Enter to cancel a previously applied match criteria.
  • ip — Enter to use IPv4 as the match protocol.
  • ipv6 — Enter to use IPv6 as the match protocol.
  • ip-any — Enter to use both IPv4 and IPv6 as the match protocol.
  • dscp dscp-value — Enter a DSCP value in single numbers, comma separated, or a hyphenated range, from 0 to 63.
  • ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
Default
Not configured
Command Mode
CLASS-MAP
Usage Information
You cannot enter two match statements with the same filter-type. If you enter two match statements with the same filter-type, the second statement overwrites the first statement. The match-all option in a class-map does not support ip-any. Select either ip or IPv6 for the match-all criteria. If you select ip-any, you cannot select ip or ipv6 for the same filter type.
Example
OS10(conf-cmap-qos)# match ip-any dscp 17-20
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\