This section is applicable to Wyse 5070, Wyse 5470, and Wyse 5470 All-in-One thin client. Use the
Display Setup dialog box to configure the display settings for the connected monitors.
To configure the display setup:
NOTE: On Wyse 5470 Thin Client, the built-in display stays on by default.
From the desktop menu, click
System Setup, and then click
Display.
The
Display Setup dialog box is displayed.
In the
Display Setup dialog box, configure the following options:
Mirror mode—Select the
Mirror mode check box to enable all connected monitors to use the same display settings configured on the primary monitor.
The following screen represents the Mirror mode configuration.
If you clear the
Mirror mode check box, the
Span Mode is enabled. The following screen represents the span mode configuration.
Blocks displayed on the screen represent the number of monitor screens connected to the thin client. Each block represents a single monitor screen.
Every monitor contains a unique display order number and display configuration. You can move the blocks horizontally or vertically and construct the multi-display layout in mixed directions. To construct a new display layout, move the blocks to your preferred position, and click
Apply. A new display layout is created. However, the system sets the block to its default position if the block is moved to an incorrect position.
NOTE:
The Wyse 5070 Extended thin client supports up to six monitors.
The Wyse 5470 Thin Client supports up to three simultaneous displays.
Main screen—Select the
Main screen check box to set the monitor as primary monitor or main screen. To set a monitor as main screen, click the monitor block, and select the
Main screen check box. After you set the monitor as main screen, the monitor block is highlighted with an underline, and the
Main screen option is disabled for that monitor block. The
Main screen option is available for other monitor blocks.
NOTE: Main screen option is effective only in
Span Mode and always disabled in
Mirror Mode.
Resolution—From the
Resolution drop-down list, select a display resolution supported by your monitor.
NOTE: The default screen resolution on the Wyse 5470 Thin Client is 1366 x 768 or 1920 x 1080 depending on the configuration. The default screen resolution on the Wyse 5470 All-in-One Thin Client is 1920 x 1080.
In
Mirror Mode, the resolution list is derived from the intersection of resolutions in all connected monitors.
In
Span Mode, select a monitor block and change its resolution from the
Resolution drop-down list.
Rotation—From the
Rotation drop-down list, select an option to rotate the monitor screen in different directions—Flip 180 degrees,
Left turn 90 degrees, or
Right turn 90 degrees. By default, the option is set to
None.
For the
Flip 180 degrees option to work efficiently, the screen direction must be at 0 or 180 degrees. If either of the 90-degree screen rotation is already applied, changing the option to
Flip 180 degrees only rotates the screen to 90 degrees more.
Click
Apply.
The new display settings are applied, and you can view the modified display.
Click
OK to confirm the new settings.
NOTE: Use the
Identify option, to know the display order number of the connected monitors.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\