- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Left-side cover
- Top cover
- Right-side cover
- Right tron-light board
- 2.5-inch hard drive
- 3.5-inch hard drive
- 2.5-inch hard-drive cage
- 3.5-inch hard-drive cage
- 550 W power-supply unit
- 1000 W Power-supply unit
- Coin-cell battery
- Memory modules
- Single-graphics card
- Solid-state drive
- Front bezel
- Top bezel
- Bottom cover
- Processor fan and heat-sink assembly
- Processor liquid-cooling assembly
- Processor
- Wireless card
- Antennas
- Front I/O-panel
- Front-chassis fan
- Top-chassis fan
- Front AlienFX LED boards
- Power-button board
- System board
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware Aurora R12 Service Manual
Removing the front-chassis fan
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the left-side cover.
- Remove the single-graphics card.
About this task
The following images indicate the location of the front-chassis fan and provides a visual representation of the removal procedure.
Steps
- Disconnect the front-chassis fan cable from the system board.
- Push the tab to release the front-chassis fan from the chassis.
- Slide and lift the front-chassis fan off the chassis.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\