Cabling PowerVault
MD1200 series expansion enclosures
You can expand
the capacity of your PowerVault MD3400 and MD3420 storage array by
adding PowerVault MD1200 series expansion enclosures. You can expand
the physical disk pool to a maximum of 120 slots (or 192, if enabled
using Premium Feature activation) using a maximum of seven expansion
enclosures.
NOTE: To
connect the MD1200 expansion enclosure to your MD Series RAID storage
array, refer to the following diagrams:
Figure 1. Single expansion
cabling diagram
Figure 2. Dual expansion
cabling diagram
To connect an MD1200 series expansion
enclosure to your MD3400 series array:
Connect the supported SAS cable (MiniSAS HD end)
to the SAS OUT Port 0 on the MD3400 series storage array.
Connect the other end of the SAS cable to the IN
port on one of the MD1200 series Enclosure Management Modules (EMM).
To add more MD1200 expansion enclosures, daisy chain
them to the first expansion enclosure.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\