Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge C4130 Owner's Manual

PDF

Installing the 1.8 inch uSATA SSD cage

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in before working inside your system.

Steps

  1. Align the tabs on the SSD cage and the PSU 1 slot with the slots on the chassis and SSD cage.
  2. Press the SSD cage until the SSD backplane engages with the SSD backplane connector on the system board.
    Figure 1. Installing the 1.8 inch SSD cage
    This figure shows installing the 1.8 inch SSD cage.
    1. 1.8 inch SSD backplane connector
    2. 1.8 inch SSD backplane
    3. 1.8 inch SSD cage
    4. tab on the SSD cage
    5. tab on the PSU 1 slot (2)
    6. slot on the chassis

Next steps

  1. Install the 1.8 inch SSD carrier or SSD blank(s) into the SSD cage.
  2. Follow the procedure listed in after working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\