Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge C4130 Owner's Manual

PDF

Removing the internal dual SD module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Locate the internal dual SD module (IDSDM) on the system board.
  2. If installed, remove the SD card(s).
    Temporarily label each SD card with its corresponding slot before removal. Install the SD card(s) into the same slots.
  3. Hold the pull tab and pull the dual SD module out of the system board.
    Figure 1. Removing the internal dual SD module (IDSDM)
    This figure shows removing the internal dual SD card module.
    1. IDSDM
    2. pull tab
    3. LED status indicator (2)
    4. SD card (2)
    5. SD card slot 2
    6. SD card slot 1
    7. IDSDM connector

    The following table describes the IDSDM indicator codes:

    Table 1. IDSDM indicator codesThe following table describes the IDSDM indicator codes.
    ConventionIDSDM indicator codeCondition
    AGreenIndicates that the card is online
    BFlashing greenIndicates rebuild or activity
    CFlashing amberIndicates card mismatch or that the card has failed
    DAmberIndicates that the card is offline, has failed, or is write protected
    ENot litIndicates that the card is missing or is booting

Next steps

Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\