Install the power supply unit (PSU) blank
when you remove PSU 2 or the 2.5 inch hard drive cage from the PSU
2 slot. Install the PSU blank only in the PSU 2 slot.
Prerequisites
CAUTION: Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Follow the safety guidelines listed in the Safety
instructions section.
If applicable, remove PSU 2 or the 2.5 inch hard
drive cage.
Steps
Align the power supply unit blank with the
power supply unit slot and push it into the power supply unit slot
until it clicks into place.
Figure 1. Installing the
PSU blank
PSU blank
PSU slot
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
