Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge VRTX Enclosure Owner's Manual

PDF

Removing the system feet

Steps

  1. To reduce the chassis weight, remove the following (if required):
    1. Front bezel (if installed)
    2. Hard drives. See Removing A Hot-Swap Hard Drive.
    3. Server modules. See Removing A Server Module.
    4. Power supply units. See Removing A Power Supply.
  2. Rotate the system feet inward.
  3. Lay the enclosure on its side on a flat, stable surface with the cover release latch side on top.
  4. Remove the screws securing the system feet to the system base cover.
    Figure 1. Removing and installing the system feet
    The figure shows removing and installing the system feet.
    1. system feet (4)
    2. screws (4)
    3. screw holes (4)
    4. system base cover

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\