- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the right-side cover
- Replacing the right-side cover
- Removing the front bezel
- Replacing the front bezel
- Removing the optical drive
- Replacing the optical drive
- Removing the top cover
- Replacing the top cover
- Removing the bottom cover
- Replacing the bottom cover
- Removing the primary hard-drive
- Replacing the primary hard-drive
- Removing the secondary hard-drive
- Replacing the secondary hard-drive
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the power-supply unit
- Replacing the power-supply unit
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the graphics card
- Replacing the graphics card
- Removing the full-length graphics cards
- Replacing the full-length graphics cards
- Removing the memory modules
- Replacing the memory modules
- Removing the power-button module
- Replacing the power-button module
- Removing the top I/O-panel
- Replacing the top I/O-panel
- Removing blower and heat-sink assembly
- Replacing blower and heat-sink assembly
- Removing the VR heat sink
- Replacing the VR heat sink
- Removing the processor fan and heat-sink assembly
- Replacing the processor fan and heat-sink assembly
- Removing the chassis fan
- Replacing the chassis fan
- Removing the processor
- Replacing the processor
- Removing the wireless card
- Replacing the wireless card
- Removing the antenna
- Replacing the antenna
- Removing the system board
- Replacing the system board
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 8910 Service Manual
Procedure
- Loosen the captive screws that secure the VR heat sink to the system board.
- Lift the VR heat sink from the system board.
Figure 1. Removing the VR heat sink 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\