Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip route

Assign a static route to the switch.

Syntax

ip route destination mask { ip-address | interface [ip-address]}[distance]

To delete a specific static route, use the no ip route destination mask {address | interface [ip-address]} command.

To delete all routes matching a certain route, use the no ip route destination mask command.

Parameters

destination	Enter the IP address in dotted decimal format of the destination device.
mask	Enter the mask in the slash prefix format (/x) of the destination device’s IP address.
ip-address	Enter the IP address in dotted decimal format of the forwarding router.
interface	For a VLAN, enter the keyword `vlan` followed by a number from 1 to 4094.
distance	(OPTIONAL) Enter a number as the distance metric assigned to the route. The range is from 1 to 255.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.

Usage Information

Using the following example of a static route: ip route 33.33.33.0 /24 tengigabitethernet 0/0 172.31.5.43

The software installs a next hop that is not on the directly connected subnet but which recursively resolves to a next hop on the interface’s configured subnet. In the example, if gig 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43 recursively resolves to 2.2.2.0, Dell Networking OS installs the static route.
When the interface goes down, Dell Networking OS withdraws the route.
When the interface comes up, Dell Networking OS re-installs the route.
When recursive resolution is “broken,” Dell Networking OS withdraws the route.
When recursive resolution is satisfied, Dell Networking OS re-installs the route.

Related Commands

show ip route — views the switch routing table.