Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor weight

Assign a weight to the neighbor connection, which is used to determine the best path.

Syntax

neighbor { ip-address | peer-group-name} weight weight

To remove a weight value, use the no neighbor { ip-address | peer-group-name} weight command.

Parameters

ip-address	Enter the IP address of the peer router in dotted decimal format.
peer-group-name	Enter the name of the peer group to disable all routers within the peer group.
weight	Enter a number as the weight. The range is from 0 to 65535. The default is 0.

Defaults

0

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

In the system best path selection process, the path with the highest weight value is preferred.

NOTE: In the system best-path selection process, the path with the highest weight value is preferred.

If you configure the set weight command in a route map applied to this neighbor, the weight set in that command overrides the weight set in the neighbor weight command.