Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

max-area-addresses

Configure manual area addresses.

Syntax

max-area-addresses number

To return to the default values, use the no max-area-addresses command.

Parameters

number

Set the maximum number of manual area addresses. The range is from 3 to 6. The default is 3.

Defaults

3 addresses

Command Modes

ROUTER ISIS

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To configure the number of area addresses on router, use this command. This value must be consistent with routers in the same area, otherwise the router forms only Level 2 adjacencies. The value must be same among all the routers to form Level 1 adjacencies.