- Notes, cautions, and warnings
- About your Dell PowerEdge FD332
- Performing initial system configuration
- Storage sled mapping configurations
- Installing and removing storage sled components
- Troubleshooting your system
- Using system diagnostics
- Technical specifications—PowerEdge FD332
- Getting help
Dell PowerEdge FD332 Owner's Manual
Storage controller module
You system
supports one storage controller module (SCM), which is available in
four options:
- FD33xS—storage controller module with single PERC
- FD33xD—storage controller module with dual PERC
- FD33xS—storage controller module with single HBA
- FD33xD—storage controller module with dual HBA
- NOTE: The default mode for all storage controller modules is HBA mode. To enable RAID mode for a PERC controller, you must upgrade to RAID mode licensing. For more information on RAID mode licensing, see the PowerEdge FX2s CMC User’s Guide at dell.com/esmmanuals. For information on how to import RAID mode license, see the Dell PowerEdge FX2/FX2s CMC Online Help.
For more information on the storage controller modules, and removing and installing the SCM components, see the Dell PowerEdge RAID Controller (PERC) 9 User’s Guide at dell.com/storagecontrollermanuals and Dell Host Bus Adaptor User's Guide at https://www.dell.com/support/home/us/en/19/products/server_int/server_data_center_infrastructure .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\