Dell PowerEdge R720 and R720xd Owner's Manual

Installing An Internal SD Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

NOTE: To use an SD card with your system, ensure that the internal SD card port is enabled in the System Setup.

Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
Open the system.
Remove the expansion-card riser 3 and any card(s) installed in the riser.
Locate the SD card connector on the internal dual SD module. With the label side facing up, insert the contact-pin end of the card into the slot.
- NOTE: The slot is keyed to ensure correct insertion of the card.
Press the card into the card slot to lock it into place.
Replace the expansion-card riser 3 and if applicable, replace the card(s) in the riser.
Close the system.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.